DMP Electronics SCS2 Uživatelský manuál stáhnout pdf (Strana 4)

JTAG-Booster for AMD ÉlanSC520

4 JTAGEL5d.doc

1. General

The program JTAGEL5 uses the JTAG port of the AMD ÉlanSC520 embedded

microprocessor in conjunction with the small JTAG-BOOSTER:

• to program data into flash memory

• to verify and read the contents of a flash memory

• to make a memory dump

• to access a I2C Device

• to test CPU signals

All functions are done without any piece of software running in the target. No

firmware or BIOS must be written. Bootstrap software may be downloaded to

initially unprogrammed memories.

For latest documentation please refer to the file README.TXT on the distribution

disk.

1.1. System Requirements

To successfully run this tool the following requirements must be met:

• MSDOS, WIN3.x, WIN9x or WinNT

(WinNT is supported with an additional support-kit)

• Intel 80386 or higher

• 205 kByte of free DOS memory

• no extended memory

• Parallel Port

1 2 3 4 5 6 7 8 9 ... 50 51

Žádné komentáře

DMP Electronics SCS2 Uživatelský manuál Strana 4